Difference between revisions of "Network PDUs"

From sshcWiki
Jump to navigation Jump to search
m (Yes! No! :()
(Documentation about password)
Line 35: Line 35:
  
 
It's not the default from the manual ("PASS")
 
It's not the default from the manual ("PASS")
 +
 +
<blockquote>
 +
The password can be up to 8 characters and is case sensitive. Please remember your password. If you forget your password the unit needs to be returned to Dataprobe or an Authorized Service Agent for reset.
 +
</blockquote>
 +
 +
Welp?
  
 
== Talking to them over RS232 ==
 
== Talking to them over RS232 ==

Revision as of 20:57, 2 April 2015

Our Stupid Network PDUs

We have two Dataprobe IP-410 network-enabled PDUs. They are a pain. Please donate us something not terrible.

Inventory

Name IP address MAC Address IP set and pinging?
sshc-cgx-pdu-01 172.16.0.55 00:0d:ad:00:1a:90 Yes
sshc-cgx-pdu-02 172.16.0.56 00:0D:AD:00:1A:94 Yes

Setting the IP address

I couldn't figure out how to get these things to set their IP addresses in anything other than Windows.

In windows, just:

arp -s <IP address> <MAC address>

and then ping the IP address.

The IP address seems to persist through resets, though I don't know quite how "sticky" it is. It lasted at least 10 minutes for me to drop the PDU back in the cabinet.

Talking to them over TCP/IP

These things communicate over HTTP and Telnet.

I have no idea what the password is.

iPal  Version 2.3d
 Please Enter The Password >

It's not the default from the manual ("PASS")

The password can be up to 8 characters and is case sensitive. Please remember your password. If you forget your password the unit needs to be returned to Dataprobe or an Authorized Service Agent for reset.

Welp?

Talking to them over RS232

"This connection provides for RS-232 connection for out-of-band connection to the iPAL. A terminal or modem can be attached directly to this 9 pin connector. With a modem attached, connection is made using PPP (Dial-up-Networking) and Telnet.

Connection directly to a laptop or terminal requires a null modem (crossover) cable.

With a terminal directly installed, a simple menu interface is used. These menus are identical to the telnet setup and control screens. Use any terminal emulation software to connect to the iPAL.

Connection parameters are: 19200bps, 8 data bits, 1 stop bit, no parity (19200,8,n,1). Set flow control to OFF."

-- Dataprobe iPal Manual


Couldn't get it to work. Systems wouldn't make a peep.

Manual

File:Ip815.pdf